The low Curled Pony { Tutorial }
- Namwedding
- May 24, 2016
- 2 min read
Lets get to the actual directions!
Tools & Supplies: hairbrush
teasing comb
clip for tying back
heat protectent
pin curl clips
curling wand
hairspray
Inspired & Repost
Thank you for stopping by!
Steps 1-3: Start by combing through your hair till it's smooth. If you have thin hair (like me:)) now would be a great time to tease your hair a bit at the back of your crown for some good lift and volume. clip up the top two thirds of your hair and (1) start curling the bottom third in large chunks with whatever hot tool you prefer:) (2) Pin up each curl as you complete it so it can set. Move on to curl the second third, and the last third, remembering to curl all the hair framing your face away from your face. Combing each section of hair before you wrap it around the iron will ensure a silkier curl. Once your whole head is pinned up (should only have a dozen or so curls) (3) give your head a spritz with hair spray.
Steps 4-6: Once your curls have cooled (a couple minutes), (4) let them all out and spray again. divide your head into rough thirds again (5) this time going vertical and leaving out the front. so you're going to have a left section and a right section that meet at the back and the front, with a very rough sort of circle of hair in the middle. (Hope that makes sense!) Grab a 2-3 inch chunk of hair right from the back of your middle section and (6) braid it, securing the end, and tugging the sides to widen the braid and give it fullness.
Steps 7-9: Take the rest of your middle section and (7) tie it in a low ponytail, tug the hair at your crown. Wrap the braid around your head (covering the part) and pin it securely. (8) Twist your side sections one at a time towards your head slightly and (9) wrap them both over the ponytail, pinning on the opposite side. Fluff your curls a bit, spray with some good hold, and you're all set to go!!!
Comments